This tensioning fitting can be used for stairways and longer, straight runs of cable where take-up is required to obtain proper tension (see below). The turnbuckle will self-adjust for stairs or angled runs. An Eye Post Assembly is included. Combine the classic turnbuckle with the following fittings based on the length of run:
0-25 feet: Combine with the Fixed Stud
26-75 feet: Combine with the Turnbuckle Stud
Over 75 feet: Combine with another Classic Turnbuckle

These classic turnbuckles are designed to be installed on to wire rope or aircraft cable.

This non-tensioning fitting is used for stairways and angled runs. A Threaded Tab is included with this Eye Fitting Assembly. Posts must be drilled and tapped to incorporate the threaded tab. This fitting can only be used when a minimum wall thickness of .250 is maintained. The hole must be drilled with an offset of 1/4"" to maintain axial alignment for the threaded tab.

These fixed eyes are designed to be installed on to wire rope or aircraft cable.

This non-tensioning fitting is used for stairways and angled runs. An Eye Post Assembly is included with this Eye Fitting Assembly. The hole must be drilled with an offset of 1/4" to maintain axial alignment for the fixed tab.

These fixed eyes are designed to be installed on to wire rope or aircraft cable.

This tensioning fitting is used for stairways with runs of moderate length. For a clean look, the fitting is assembled inside the post. For assemblies with wooden posts, fender washers are necessary. (See ""Replacement Parts"".) Combine the classic turnbuckle with the following fittings based on the length of run:
0-25 feet: Combine with the Fixed Stud
26-75 feet: Combine with the Turnbuckle Stud
Over 75 feet: Combine with another Classic Turnbuckle

These turnbuckle studs are designed to be installed on to wire rope or aircraft cable.

This tensioning fitting is used straight runs of moderate length. For a clean look, the fitting is assembled inside the post. For assemblies with wooden posts, fender washers are necessary. (See ""Replacement Parts"".) Combine the classic turnbuckle with the following fittings based on the length of run:
0-25 feet: Combine with the Fixed Stud
26-75 feet: Combine with the Turnbuckle Stud
Over 75 feet: Combine with another Classic Turnbuckle

These turnbuckle studs are designed to be installed on to wire rope or aircraft cable.

This non-tensioning fitting is used straight runs. For assemblies with wooden posts, fender washers are necessary. (See ""Replacement Parts"".)

These fixed studs are designed to be installed on to wire rope or aircraft cable.

This tensioning fitting is used to obtain a more substantial architectural look or for longer, straight runs of cable where a lot of take-up is required for proper tension (see below). This fitting is threaded into cement posts with a drop-in anchor system. Combine the classic turnbuckle with the following fittings based on the length of run:
0-25 feet: Combine with the Fixed Stud
26-75 feet: Combine with the Turnbuckle Stud
Over 75 feet: Combine with another Classic Turnbuckle

These classic turnbuckles are designed to be installed on to wire rope or aircraft cable.