Diameter | 
                                                                        N/A 1/16 " | 
                                                                                MBS (lbs) | 
                                                                        N/A 480 | 
                                                                                Put-Ups (FT) | 
                                                                        N/A 250' 500' 1000' 5000' | 
                                                                                WT/1000FT (lbs) | 
                                                                        N/A 7.5 | 
                                                                                Construction | 
                                                                        N/A 7x7 | 
                                                                                Material Type | 
                                                                        N/A GAC | 
                                                                                Cross Reference | 
                                                                        N/A 1167BGACP | 
            **Commercial grade is NOT intended for aircraft use.
*Material origin is import unless requested otherwise.
Warning: Wire rope & aircraft cable should never be used at breaking strength. 10:1 safety factor minimum is recommended for critical/overhead application. Do not use for overhead lifting without consulting a wire rope rigging professional. End fittings may not hold to 100% of strength efficiency so a safety factor such as 5:1 should be divided into the assembly actual strength. A pull test is recommended for quality assurance.
*Material origin is import unless requested otherwise.
Warning: Wire rope & aircraft cable should never be used at breaking strength. 10:1 safety factor minimum is recommended for critical/overhead application. Do not use for overhead lifting without consulting a wire rope rigging professional. End fittings may not hold to 100% of strength efficiency so a safety factor such as 5:1 should be divided into the assembly actual strength. A pull test is recommended for quality assurance.